TRUSTED HEATING, COOLING & CONSTRUCTION
Livermore summers can push past 100°F, and winter nights in the valley still get cold. A heat pump handles both seasons with one system. Trusted Heating Cooling & Construction provides heat pump installation, replacement, repair and maintenance for homes across Livermore and the Tri-Valley.
Call our Livermore line at (510) 605-6248 to talk about a heat pump for your home.
Livermore sits inland, east of the hills that keep Fremont and Union City mild. In July and August the valley regularly sees afternoons above 100°F, and in December and January overnight lows can drop close to freezing.
A heat pump does both jobs. In summer it pulls heat out of the house like an air conditioner. In winter a reversing valve flips the refrigerant flow, so the same outdoor unit gathers heat from outside air and moves it indoors. Because it moves heat instead of burning fuel, a properly sized heat pump heats efficiently through a typical Livermore winter.
Most heat pump Livermore questions start the same way: can one system handle both seasons here? In most homes, yes. Newer houses in South Livermore and older ranch homes in Springtown can both be good candidates when the system is sized for the house.
From a first-time conversion to a yearly tune-up, we handle the full life of your heat pump.
Switching from an AC and furnace, or adding comfort to a home that never had it. We check the electrical service, place the outdoor unit for airflow and noise, and match the indoor equipment.
When an older heat pump is failing, we size the new one from your home as it is today, not the old nameplate, and test it in both heating and cooling.
No heat, weak cooling, ice that will not clear or odd noises. We test the electrical parts, refrigerant charge, reversing valve, defrost controls and airflow to find the real fault.
A heat pump runs in summer and winter, so it works more hours than an AC alone. A yearly check of coils, connections, refrigerant charge and drain keeps it ready for both seasons.
A ducted heat pump connects to your existing duct system through an indoor air handler or a coil on the furnace. It is usually the natural choice when the ductwork is in reasonable shape. Before quoting, we check the ducts in the attic or crawlspace for leaks, crushed runs and missing insulation, and confirm they are sized for the airflow a heat pump needs.
A mini-split uses a compact outdoor unit and one or more wall-mounted indoor heads, with no ducts at all. It suits older homes without ductwork, additions, converted garages and ADUs.
The size of a heat pump matters more than the brand on the side of it. An oversized unit short cycles and wears out sooner. An undersized one runs nonstop on hot afternoons and struggles after a cold night.
We size heat pumps with a Manual J load calculation, the ACCA method for working out how much heating and cooling a specific home needs. It accounts for insulation, windows and sun exposure, air leakage and Livermore’s design temperatures. Then we choose equipment that covers both the summer cooling load and the winter heating load.
In California, installing or replacing a heat pump generally requires a building permit, and the work must meet the state’s Title 24 energy standards, which can include duct leakage testing. We pull the permit, schedule the inspection and handle the required testing as part of the job.
Small faults are easier to fix when they are caught early. Call if you notice any of these.
Common causes include a thermostat in the wrong mode, a failed capacitor or contactor, or low refrigerant from a leak. We test each one instead of guessing.
Light frost on a cold morning is normal. Thick ice that stays usually points to a defrost problem, low refrigerant, a failed outdoor fan or blocked airflow.
If the defrost board, sensor or timer fails, the outdoor coil ices over and heating output drops. A system stuck in defrost can blow cool air indoors.
When the reversing valve or its solenoid sticks, the heat pump may blow cool air in winter or warm air in summer. We confirm the fault before replacing a valve.
A heat pump that turns on and off every few minutes may be oversized, low on refrigerant, choked by a dirty filter or reacting to a badly placed thermostat.
A whoosh during defrost is normal. Grinding, rattling, screeching or loud buzzing can mean a failing fan motor, loose parts, a compressor issue or an electrical fault.
A single failed part on a heat pump in good condition, such as a capacitor, fan motor or defrost sensor, is usually worth repairing. Replacement deserves a closer look when an older system needs a compressor or reversing valve, still runs on R-22 refrigerant, breaks down every year, or was the wrong size from the start.
We explain both options and you decide. Cost depends on the equipment, the problem, the size of the home, access and permit requirements, so we quote after we have seen the system. If the issue is only on the cooling side, our AC repair service in Livermore can help. If you are leaning toward new equipment, see our AC replacement and installation in Livermore page.
Heat pump incentives in California change often, and what you qualify for depends on your utility, your home and the equipment you choose. Before you buy, check TECH Clean California for current heat pump incentives, and check with PG&E or your electric utility for any rebates they offer right now.
With every heat pump quote, we give you the model numbers and efficiency ratings you need to check eligibility. Amounts and approval are set by each program.
We work across Livermore, including South Livermore, Springtown and the downtown area, and in nearby Pleasanton, Dublin, Tracy and Sunol.
Still deciding between a heat pump and a new furnace? Read our guide on heat pump vs furnace for Fremont and Union City homes. The same points apply in Livermore, where summers are hotter. Outside the Tri-Valley, see our heat pump services in Fremont.
Yes, when it is sized correctly. A heat pump cools the same way a central air conditioner does. The key is a Manual J load calculation using Livermore’s summer design temperatures, plus ductwork that can move enough air.
For most homes, yes. Livermore winters are cold for the Bay Area but mild compared with many places where heat pumps are common, and modern units keep producing heat below freezing.
Light frost on a cold morning is normal, and the defrost cycle should melt it. Thick ice that does not clear often points to a defrost control, refrigerant or fan problem, so call for service.
If your home has ductwork in reasonable condition, a ducted heat pump usually makes sense. For homes without ducts, additions, garage conversions or ADUs, a ductless mini-split is often the better fit.
Generally, yes. Heat pump installations in California typically require a building permit and must meet Title 24 energy requirements. We pull the permit and coordinate the inspection.
There may be. Check TECH Clean California and PG&E or your electric utility for current heat pump rebates, since amounts and eligibility change. We can give you the equipment details you need to apply.
Whether you need a new system, a replacement or a repair, call our Livermore line and tell us about your home and the equipment you have now.